User Manual HWAM® SmartControl™ Generation 2

19
2 3
8
1
4 5
6 7
1
Turn the unit on its rear end.
2
Unscrew the four screws on the backside (as shown
in the picture) to access the batteries.
3
Remove the lid from the unit.
4
Replace the  AA batteries. Always replace all  bat-
teries at the same time, and do not use old batteries.
Do not use rechargeable batteries.
5
It is important to ensure that the batteries are prop-
erly positioned in the unit. Make sure the batteries
are positioned as shown.
6
When the new batteries are positioned correctly,
the device can be reassembled - put the lid on the
device.
7
Screw the  screws in again as shown on the image.
Be careful not to overtighten them.
8
The batteries have now been replaced and the
device is ready for use.
Used batteries should not be thrown in the trash, but
should be disposed of properly.
Changing the batteries of the room temperature sensor
The wireless room temperature sensor requires  AA batteries. These are not included in the
package. In order to install and / or replace the batteries, follow these instructions carefully.
HWAM® SmartControl™ will automatically notify you when it is time to replace the batteries in
the wireless room temperature sensor.