Operation Manual

2. Attachment of electrode lead wires
a Insert the plug into the electrode socket on the main apparatus.
b Connect the snap-fasteners at the other end of the wire to the
electrode pads.
c Place the electrode on your body as directed by your physician.
- Clean the wires by wiping with a damp cloth.
- Coating them lightly with talcum powder will reduce tangling and
prolong life.
3. Operating instructions
a Press the “ON/+” button, the device will be put on, the LCD light all
display for 1 second, then the device goes into standby mode and
waits for your settings.
b First, ensure the time of therapy. Defaulted the time is 15 minutes and
it is fi xed and can not be set by user.
c Second, select the mode of therapy by pressing the “PRG/STOP” button.
9 modes can be selected, increasing the number of mode by every
pressing, and return to mode 1 from 9.
d As followed, press the “ON/+” to increase the intensity or “OFF/-”
button to decrease the intensity, then the device starts to treat. Note:
different person need different intensity, so you must increase the
intensity from 0 to 9 slowly and carefully, stop to increase when you
feel comfortable.
e In treating, the ‘hand’ sign in LCD fl ashes until the time of therapy is
exhausted.
f After treatment, the device will be shut off automatically
Clean the electrodes
- You should hold the plug when pulling it out. Please do not pull the
wire.
- Please use clear water to wash or use wet cloth (instead of facial tissue)
to gently wipe up the electrodes when cleaning them. Do not use brush
or fi ngernail to clean surface of the electrodes to avoid scratching them.
ENGLISH
25