Manual

ManualsBrandsHydro-Logic ManualsAccessories for waterMERLIN Garden Pro - Pressure Booster Pump

Instructions For:

Start by snapping on the black heat sink

onto pump body. Install the pump on the

inlet tubing (1/2” clear) of the Merlin-

Garden Pro. Simply cut the inlet tubing

somewhere close to filter unit and push each

cut end into the fittings on the pump. NOTE:

there is an arrow indicating direction of flow

of the water on the pump.

The pump has a built in pressure switch

which automatically turns the pump off when

there is an increase in pressure downstream

of pump. In other words, by shutting off the

3/8” shut-off valve, included with the

Merlin-Garden Pro, the line pressure will

increase and the pump will shut off. DO

NOT attempt to shut off flow of water enter-

ing the pump. The pump will not shut off and

will quickly burn itself out. If you need to shut

off the flow of water entering the pump,

unplug the pump’s power cord. This is not

covered under warranty.

DO NOT attempt to use the Merlin-Float

Valve Kit (shown below) in conjunction with

the pump. The pump is too powerful for the

float kit and will not shut down properly and

eventually burn out. This is not covered

under warranty.

You must use the Electronic Shut-Off kit

(shown below) for the Merlin-Garden Pro if

you wish to use a float option. This can be

viewed at www.hydrologicsystems.com

and you can inquire at your dealer.

When the pump reaches its thermal limit, it

will shut down until it cools off a bit, and

then re-start until the next thermal cycle. DO

NOT attempt to unplug the pump from

power and restart it. It cycles for a reason. If

you attempt to by-pass the thermal cycling,

you will burn out the pump. This is not

covered under warranty.

MERLIN

Garden Pro

Pressure

Booster Pump

• Increase ﬂow rate of pure water line

• Provides constant 65 psi of pressure to unit

• Ideal for well water and gravity feed situations

*optional pump protector available (HL#29040)

- see website for more info

The Merlin-Garden Pro is designed to run on inlet line pressure between 40-80 psi. If you are

experiencing less pressure and low flows, or just want to maximize your flow rates, the booster pump

will increase inlet pressure to a constant 65 psi. The pump is designed specifically to work with the

high flow rates required by the Merlin-Garden Pro. It has a custom micro-processor that allows the

pump to run for long periods of time.