Technical Specifications

D
U
Jet &
Control
placement
may vary
41"
115º
24" 18" 22"
11"
Backrest angle
NOTE:
Graphics may not be to scale. Specications and features are subject to change without notice and are ± .25”. All nal measurements should be taken
from tub on site. Access 18”x 18” or larger is required for each pump. Some pump locations and plumbing may extend beyond the perimeter of the bath.
Hydromassage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com
X HTT® Leg Therapy Air Massage System includes 10 Air Jets on the
oor. Optional on Combo Plat and Combo Gold Series
X 6 Jet HTT® Back Massage System: N/A on Combo Series-Standard
on Plat series
Warm Back Tubing Zone
A
B
C
BATHERS: 2
INSTALLATION
• DECK (D)
• UNDER MOUNT (U)
ALCOVE (A)
FREESTANDING (F)
CLAWFOOT (L)
PEDESTAL (P)
raised headrest
lip prole
rounded
lip prole
Bath includes EZ Level Legs
INSTALLATION WILL NOT REQUIRE MORTAR BEDDING
Zen Oval HS6642SD 66" x 42" x 24"
PRODUCT NUMBER: ZOHS6642SD
HYDRO SILVER SERIES
TECHNICAL SPECIFICATIONS
Drain Side drain
Pump Conguration: Select 1 Std. = Standard / Alt LF/RF Optional
Bath Weight (empty) 160 lbs
Gallons to Operate 60-85
ELECTRICAL SPECIFICATIONS
Motor/Pump (1) 115v 20AMP GFCI Circuits
Inline Stainless Steel Heater (Opt) 115v 20AMP GFCI Circuit
STANDARD FEATURES & ACCESSORIES for HYDRO SILVER SERIES BATHS ______
OPTIONAL FEATURES & ACCESSORIES
(Please type in the box below)
JETS
9 Water Jets
Tri-Zone Back Systems 3 Jets
Ultra Flow Jets
Micro Flow Jets
PUMPS
2.25 Hydropower 1-speed Pump
Quiet Pad Anti-Vibration Mounted Pump
CONTROLS
Air Switch On/Off Control(s)
PURITY
HydroClean Water Purity System
HydroCleanse
STANDARD ACCESSORIES
FDA Recipe Non-Toxic Food & Beverage Grade
Plumbing (primarily)
30 Point Quality Assurance Factory Test
EZ Level Adjustable Legs
REQUIREMENTS
Pump Locations: Select 1
Electrical: one 115v 20AMP GFCI Circuits
Tub should not be supported by the lip in any way.
Level tub & screw or glue adjustable legs to sub oor.
CUT OUT DIMENSIONS:
OVALS: A template will be provided
RECTANGLES: Subtract 1” to 1.5” from length & width for hole
cut out size
EZ CLEAN CAST ACRYLIC
LIMITED LIFETIME WARRANTY
ANSI