User manual

How to bind DSMX compatible Satellite to Flight Controller without main Rx:
1.Make sure that satellite has been connected correctly.
2.Connect Naze32 to USB
3.Open baseflight/cleanflight and connect to Naze32 (baseflight/cleanflight app in Chrome)
4. From Configuration tab make sure that you have selected "Enable Serial-based receiver" and select.
SPEKTRM2048 for DSMX.
5. From CLI tab type: "set spektrum_sat_bind = 9" for DSMX
6. Type "save" and after Naze32 reboot remove USB cable (Fully Power off the Flight Controller)
7. Wait a few seconds and reconnect the USB cable. After cold start satellite led should start blinking
and transmitter should be turned on while pressing the bind button.
8. After binding satellite led should be solid. Connect cleanflight/baseflight and use receiver tab to test
that satellite is working correctly.
9.Final step is to go to CLI tab and type "set spektrum_sat_bind = 0" and then type "save". This must
be done so that satellite doesn't go back to binding mode when Naze32 is repowered again.
NOTICE
- For more information on the Hyperion receivers, see www.Hyperion-World.com
website for more product details.
- This is not a Horizon Hobbies DSM2™, DSMX™ product, and is not manufactured or
endorsed by Horizon Hobbies LLC. DSM2, and DSMX™ are registered trademarks of
Horizon Hobbies LLC.
- Accepted by the MAAA in Australia, see the MAAA MOP58 for guidance