User manual

some reason it is not done correctly in the first place or things change later, there will be an

offset on one or more channels. This will show up as control surface deflection when

stabilization is turned on, followed by a return to neutral when stabilization is turned off.

Correcting this issue requires recalibration of the gyros.

Recalibration is only needed if a control surface moves from neutral and stays

there when the stabilizer is turned ON, then returns to its previous position when

the stabilizer is turned OFF.

Please note: Gyro recalibration has nothing to do with the “double toggle” gesture

mentioned. The purpose of that feature is to allow the stabilizer to identify the

current neutral positions of the Sticks.

How to recalibrate the gyros.

Stabilizers can be recalibrated by the user,

Recalibrating (green flashes only at power-on)

1) Unplug any power source for the stabilizer.

2) Connect two bind plugs as shown in the photo.

3) Provide power for the stabilizer. Make sure the

gyro does not move. It must experience

absolutely no vibration or movement. The green LED

will flash 3 times to indicate the beginning of gyro

calibration.

4) After 1 second the green LED will again flash 3

times to indicate gyro calibration complete.

5) Remove the two bind plugs.

6) Power cycle the unit and test operation.

7) If the offset problem is not solved, repeat the

above steps and make sure there is no movement or

vibration of the unit. Even a tiny,

invisible movement will prevent proper calibration.

Note: It should not be necessary to re-bind the receiver to the transmitter after this

procedure.

NOTICE

for more details visit www.Hyperion-World.com. In using this manual, you agree that

you accept all responsibility.

This is not a Horizon Hobbies DSM2™, DSMX™ product, and is not manufactured or endorsed

by Horizon Hobbies LLC. DSM2™, and DSMX™ are registered trademarks of Horizon

Hobbies LLC.