User manual

6. Connect servos and speed control (ESC), set switches and wing type
Plug the servos and ESC into the appropriate slots on the receiver. Normally, the Gear slot
(channel 5) will be empty, as it is used internally by the receiver to turn stabilization
on/off. Set switches J4, J5 and J6 on the receiver as indicated below.
For Spektrum™ transmitters, set wing type on the transmitter as shown; in all cases, the tail
type is Normal. Note that mixing for elevons or V-tail is done in the receiver; the
transmitter must NOT be programmed for V-tail or elevons. By default the switches on the
stabilizer are OFF. This means the stabilizer is inactive and the receiver operates as a
normal unstabilized 7-channel receiver.
Conventional controls with single aileron servo or two servos and a Y-cable:
Channels: 1 –THR, 2 – AIL, 3 – ELE, 4 – RUD, 5 – XXX.
Switches: J4 – ON, J – 5 ON, J6 – OFF. Wing type: Normal.
Conventional controls with aileron servos on separate channels:
Channels: 1 – THR, 2 – R-AIL, 3 – ELE, 4 – RUD, 5 – XXX, 6 – L-AIL.
Switches: J4 – ON, J – 5 ON, J6 – ON. Wing type: Dual Ail or Flaperon.
Elevon (Delta wing) control configuration:
Channels: 1 – THR, 2 – R-ELEV, 3 – L-ELEV, 4 – RUD3, 5 – XXX.
Switches: J4 – ON, J – 5 OFF, J6 – OFF. Wing type: Normal (NOT Delta).
V-tail control (single aileron servo or Y-cable):
Channels: 1 – THR, 2 – AIL, 3 – R-TAIL, 4 – L-TAIL, 5 – XXX.
Switches: J4 – OFF, J – 5 ON, J6 – OFF. Wing type: Normal. Tail type: Normal (NOT V)
V-tail control (separate aileron servos):
Channels: 1 – THR, 2 – R-AIL, 3 – R-TAIL, 4 – L-TAIL, 5 – XXX, 6 – L-AIL.
Switches: J4 – OFF, J – 5 ON, J6 – ON. Wing type: Dual Ail or Flaperon. Tail type: Normal.
Important safety warning: Leave the motor unconnected or remove the propeller
when testing or programming. Electric models can cut you. Summary of the
Settings for Various Control Configurations