User Manual

4
Make sure the cable is plugged in completely to ensure a good connection. DO NOT disturb the cable once it
is connected to the diagnostic port. The programmer will power up, and display the startup screen.
Turn the key to the Run position, and select “OK” using the middle bottom button. The Run position is the last
key click before the engine will start. DO NOT START THE ENGINE AT ANY TIME DURING THE
PROGRAMMING PROCESS! You should hear your seat belt chime and warning light on the instrument
panel when the key is in this position. For keyless ignition/push button start vehicles, press the ignition button
until it cycles to the Start/Run mode. The programmer will then read out the VIN number, and after a few
seconds, display the Main Menu.
1-1: MAIN MENU
Use the left and right buttons at the bottom of the screen to scroll through the menu options. Press the middle
button to ‘Select’ an option. Press the left button to go ‘Back’ to the last menu screen.
TUNING (All Vehicles):
This is the main option in the programmer. It has selections for the Hypertech Power Tuning, and other
adjustable features.