user manual

1. See Figure N. Locate the fuse

block panel. The panel is

marked “Fuse Panel” in the

upper left corner. Using a

flathead screwdriver, loosen

the four (4) retaining clips by

turning them a half turn. Then

remove the panel and set aside.

2. See Figure O. There are four

(4) bolts that hold the fuse

block in place. Use a 10mm

socket or nut-driver to remove

these bolts and pull out the

fuse block. Swing the block

out and to the left to access

the lower edge of the dash.

3. The suggested location area

for the switch installation is

shown in Figure P.

4. Using the template provided

on page 14 of these

instructions, locate and drill

a 3/8” hole in the desired

location for the switch and a

1/8” hole below and to the

right of the main hole.

This 1/8” hole is used to lock

the switch in place.

Note: Make sure that there

are no obstructions behind the

chosen location, prior to drilling. In addition, use the

Hypertech switch assembly to check that the location

of the hole will allow enough room for the switch.

Option 2 (Drilling required)

Figure N

Fuse block

panel

Fuse block

Figure O

Option 2

mounting location

Figure P