user manual

5. See Figure Q. On the Hypertech Rotary Power Selector switch,

remove the mounting nut and washer from the switch shaft.

There is one (1) additional ring on the switch shaft. The tab on

this ring needs to remain in position number 4 when the switch

is installed. From behind the panel, insert the switch into the

panel hole. Line up the positioning tab into the small drilled

hole. On the outside of the dash, place the provided Hypertech

switch plate over the shaft. Make sure that the plate is lined up

so that the numbers 1 and 2 are spaced equally on either side

of the 12 o’clock position. Secure the switch in place with the

washer and mounting nut. Using the small screwdriver

provided, install the knob onto the switch shaft. The screw

should set against the flat portion of the knob shaft. Rotate the

knob left (counter-clockwise) until you reach the stop. The

white indicator on the knob should now point to the number 0

on the switch plate.

6. Temporarily re-install the fuse block (Step 2) so that it is out of

the way during the next step.

7. See Figure R. From inside the vehicle, look below the dash at

the firewall, behind the parking brake, and locate the large

rectangular grommet. Using a 1/2” drill bit, carefully drill

a hole through the grommet into the engine compartment.

(

Note: Prior to drilling, make sure that no obstructions

exist on the engine side of the grommet.)

8. Remove the fuse block and pull to the side, as performed in

Step 2 of the power selector installation.

9. Beneath the dash, route the switch cable along existing cable

paths toward the 1/2” hole. Feed the connector through the

1/2” hole.

Figure Q

Figure R

Rectangular

grommet

Hypertech

rotary switch

Headlight

controls