user manual

10. See Figure S. From the engine side, pull the connector and

cable through the firewall. Attach the connector to the main

Hypertech cable by mating the two (2) 4-pin connectors.

NOTE: The latch on the switch cable connector should

snap over the tab on the mating connector.

11. Use the tie-wraps provided to secure the cable to existing

cables, both inside beneath the dash and inside the engine

compartment.

Note: Beneath the dash, make sure that

the switch

cable is out of the way and clear of the parking

brake assembly

and driver’s leg and foot area. In the

engine compartment, make sure that the switch cable

is routed away from sources of heat.

12. Beneath the dash, use the provided small tube of silicone

to seal the grommet hole around the cable if desired.

The silicone will be dry to the touch in about 1 hour,

and fully cured in about 24 hours.

13. Re-install the fuse block and fuse block panel.

14. Check entire installation to make sure that all cables are

secure. Use additional tie-wraps to secure as necessary.

Figure S