user manual

13
USER INSTRUCTIONS
NOTE: Due to the adaptive learning strategy, the vehicle
will need to be driven about 10 miles (or 15 minutes) on
the 0 position (stock tuning) if the Power Tuning Module
is ever removed and re-installed.
Once you have completed all installation instructions, complete
the following steps setting or changing power levels.
1. Set the rotary power selector switch to 0 (stock tuning).
2. Start the engine. Keep the transmission in PARK.
3. Bring the engine up to a normal operating temperature level.
NOTE: The engine MUST be at operating temperature
for tuning to be accepted (Typically five (5) minutes of
normal engine operation is sufficient to initiate tuning).
4. Select the tuning level by turning the rotary power selector
switch from position 0 to position 1, 2, or 3.
a. Setting 0 is the stock engine tuning.
b. Setting 1 is Stage 1 engine tuning (
+56 HP).
c. Setting 2 is Stage 2 engine tuning (
+82 HP).
d. Setting 3 is Stage 3 engine tuning (
+125 HP).
Changing Power Levels
1. You can change power levels while driving by performing the
following steps:
a. Back off the throttle (to reduce strain on the powertrain).
b. Select tuning level 1, 2, 3, or 0 (back-to-stock).
c. Resume normal driving operations.