user manual

7
IV. Position the Hypertech mounting bracket & PTM
11. See Figure G. Keeping
the Hypertech cable out
of the way, position the
mounting bracket on the
rear side of the power
steering fluid reservoir.
There is a bracket with
two (2) holes on this
side of the power
steering fluid reservoir.
Align the mounting
clips with these holes
and secure the
Hypertech bracket
using the phillips-head
screws provided.
12. See Figure H. If you
previously removed the
clutch fluid reservoir
(Manual transmission
applications), re-mount
the reservoir to the
holes located above
the Hypertech in-line
Power Tuning Module
on the Hypertech
mounting bracket.
Two (2) retaining
plugs have been
provided, in case
the originals were damaged when you removed them.
Push the retaining plugs in all the way to secure the
clutch fluid reservoir to the Hypertech mounting bracket.
13. See Figure I. The
large connector on the
Hypertech cable,
marked C5, will plug
into the PCM where
the factory cable was
removed in Step 7 on
page 5 (Figure C).
There must be
enough room beside
the cable to r
e-install
the primary battery cover.
Figure G
Mounting
bracket
Figure H
Figure I
Retaining
plugs
PTM and
mounting
bracket
Clutch
fluid
reservoir
Vehicle
PCM
C5 connector