user manual

8
14. See Figure J. Route the remaining large connector (marked C4)
on the Hypertech cable between the power steering fluid
reservoir and the brake fluid reservoir. Position the two (2)
large connectors (one is the connector removed from the
middle of the PCM) to mate to each other. Mate the connectors
and lock the lever.
V. Reconnect the batteries
NOTE: When the battery is disconnected and re-connected,
some abnormal conditions may occur while the vehicle
re-learns it adaptive strategy. This typically requires the
vehicle be driven about 10 miles (or fifteen minutes) in
the “stock tuning” (setting) mode of operation. This should
be done after installation is complete.
15. See Figure K. There is one (1) section of the Hypertech cable
remaining. It has a small, 4-pin connector (C6). Set this out of
the way of the primary battery and proceed with re-attaching
the battery cover and cables.
Figure J
Figure K
C6 connector