user manual

9
16. Re-install the battery cover onto the primary battery (driver’s
side of the engine compartment). Make sure the cables
around the cover are positioned such that the cover can
be properly seated when installed. Connect the secondary
battery positive cable (passenger side of the engine
compartment). Connect the primary battery positive cable
(driver’s side of the engine compartment). Connect the
primary battery ground cable (driver’s side of the engine
compartment). Connect the secondary battery ground cable
(passenger side of the engine compartment).
INSTALLING ROTARY POWER SELECTOR
Below are two (2) possible ways to install the Hypertech Rotary
Power Selector for the Power Tuning Module. The first method
requires no drilling. The second requires some drilling and mounts
the
Rotary Power Selector in the dash below the headlight controls.
The Rotary Power Selector can be mounted in any location in
the vehicle, as these are only suggestions of possible mounting
locations.
1. See Figures L & M. Route the Rotary Power Selector switch
cable from the Hypertech Power Tuning Module along the
driver’s side inner fender
panel, past the hood hinge, and
toward the windshield molding
(as shown in Figure L). Then
route the cable beneath the
driver’s side door molding and
into the cab at the left edge of
the dashboard (as shown in
Figure M). Once this cable
routing is completed, attach
the Rotary Power Selector
switch to the cable. The switch
can now be mounted in a
convenient location or the
cable and switch coiled for
storage behind the driver’s
side dashboard for easy access
when a tuning level change is
desired.
(NOTE: This method
is provided for installations
where it is undesirable to
drill a mounting hole in the
dashboard. For a more permanent installation of the
Rotar
y Power
Selector
switch, option 2 is pr
ovided.)
Figure M
Option 1 (No drilling required)
Figure L