Operation Manual

479
Features of your vehicle
If you move the shift lever to the R
(Reverse) position with the ignition switch
on, the back-up light will illuminate, the
rearview camera cover will open and
then the rearview camera will activate.
When moving the shift lever from R
(Reverse) into P (Park), D (Drive) or N
(Neutral), the rearview camera cover will
close after 10 seconds.
✽
NOTICE
Closing the rearview camera cover
makes a sound, but it is normal condi-
tion.
The rearview camera may be turned off
by pressing the ON/OFF button when the
rearview camera is activated.
To turn the camera on again, press the
ON/OFF button again when the ignition
switch is on and the shift lever in R
(Reverse). Also, the camera will turn on
automatically whenever the ignition
switch is turned off and on again.
REARVIEW CAMERA (IF EQUIPPED)
WARNING
• This system is a supplementary
function only. It is the responsi-
bility of the driver to always
check the inside/outside rearview
mirror and the area behind the
vehicle before and while backing
up because there is a dead zone
that can't be seen through the
camera.
• Always keep the camera lens
clean. If lens is covered with for-
eign matter, the camera may not
operate normally.
OGDE042099
OGD041100
Rear view display
CAUTION
• Before washing the vehicle,
check that the rearview camera
cover is closed. If you wash the
vehicle while the rearview camera
cover is opened, the rearview
camera may be damaged.
• Do not try to open the rearview
camera cover manually. The
rearview camera may be dam-
aged.
CAUTION
If the rearview camera was jammed
with ice, the camera would not
operate normally. Use an approved
spray de-icer (not radiator
antifreeze) to release the frozen
mechanism or move the vehicle to a
warm place and allow the ice to
melt.