Network Device User's Guide

3-5
Quick Start
3. Controlling Outlets: You may wish to perform the following tests in
order to make certain that the switched outlets are functioning properly.
a) Reboot Outlet: At the command prompt, type /BOOT 1 and press
[Enter]. The status indicator for Plug 1 should go Off, pause for a
moment and then go back On, indicating that the boot cycle has been
successfully completed.
b) Switch Outlet Off: At the command prompt, type /OFF 1 and
then press [Enter]. The status indicator for Plug 1 should go Off,
indicating that the command has been successfully completed.
Leave Plug 1 in the "Off" state, and then proceed to the next step.
c) Switch Outlet On: At the command prompt, type /ON 1 and press
[Enter]. The status indicator for Plug 1 should then go back On,
indicating that the command has been successfully completed.
4. Exit Command Mode: To exit command mode, type /X and press
[Enter]. When the "Sure" prompt is displayed, type Y and press [Enter].
This completes the Quick Start instructions for the CMS-6R4. Prior to placing
the unit into operation, it is recommended to refer to the remainder of this
user’s guide for important information regarding advanced configuration
capabilities and more detailed operation instructions.