Owner manual

USING THE REFRIGERATOR IN A VEHICLE
- Connect the feeding cable to a direct current 12 or 24 V DC power source.
- Make sure the polarity is right.
- The supply line is protected by a 15 A fuse located on the box.
- If connected to an existing cigarette plug, carefully check up that power supply is sufficient.
- If the supplied power cable is not used, see the table containing the information related to
the cable section:
CABLE AREA
2
mm (AWG)
MAX CABLE LENGHT METRES (ft)
12V 24V
2,5 (AWG 13) 2,5 (8 FT) 5 (16FT)
4 (AWG 11) 4 (13 FT) 8 (26 FT)
6 (AWG 9) 6 (20 FT) 12 (40 FT)
USE
TIPS
1) Use the product in MAX mode in these cases:
- use of the product as refrigerator with high ambient temperature;
- when the suitable temperature need to be achieved in few time.
2) Use the product in ECO mode in these cases:
- use of the product as refrigerator and, in particular, with low ambient temperature;
- when the vehicle is parked for long time (with engine switched off)
- Plug in the DC or AC power. Press the button “ON/OFF” to run the refrigerator. The LED display on the
control panel would be lighted and the interior temperature would be displayed.
- Press the button and to adjust the temperature. Press the button to increase while the
button to decrease the temperature. When press the above two buttons at the same time, it would
switch the display between °C and °F.
- Press the ECO key to enter the "ECONOMY" operating mode: the ECO light turns on and the com-
pressor runs at minimum speed by keeping a fresh temperature inside the refrigerator. By pressing
the ECO key again, the light turns off and the refrigerator enters in MAX mode (mode (maximum
number of compressor turns)). MAX light will be switched on until having achieved the temperature set
.
ECO
MAX
ON/OFF MAX/ECO
4
15A
FUSE
DC12V/24V
DC12V/24V
15
LOWHIGH MED
15
50HZ/60HZ
AC110-1
20V/220-240V
- When the appliance is on, press the "+" and "-" buttons at the same time to switch back and forth between
Celsius and Fahrenheit.