Owner manual

Compressor station
Functions and features.
This is an electronic device which has the function of piloting the motor of the compressor and carrying
out all the controls and electrical protection of the system.
Its main features are as follows:
a) Protection of the battery through automatic turning off of the compressor when the feeding voltage
reaches the minimum threshold.
b)The compressor will start up again automatically when the voltage goes back to normal values.
Note: these values have been measured at control unit input and/or on the DC socket.
Battery protection
(SWITCH POSITION)
LOW
MED
HIGH
Cut-out 12V
9.6
10.1
11.1
Cut-in 12V
10.9
11.4
12.4
Cut-out 24V
21.3
22.3
24.3
Cut-in 24V
22.7
23.7
25.7
- This model can be fed equally using 12/24V or mains power (110V - 120V AC).
- It is equipped with 2 sockets to connect the two different cables for DC respectively AC.
- The refrigerator is provided with automatic switch over from one kind of feeding to the other.
- Should both be present at the same time, the device will always set itself on mains power priority feeding
by 110V - 120V AC.
USING THE REFRIGERATOR AT HOME
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them hitting against
each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
Defrosting is needed when the layer of frost is thicker than 4 mm.
To carry out this operation, turn off the refrigerator.
Do not use sharp or cutting tools to remove the layer of frost or ice.
Wait until complete unfreezing and then turn on again.
5
15A
FUSE
DC12V/24V
DC12V/24V
15
LOWHIGH MED
15
50HZ/60HZ
AC1
10-120V/220-240V
FILLING
DEFROSTING
ELECTRONIC CONTROL