Operation Manual

ManualsBrandsIcon ManualsExercise BikeCUP S XPOWER E200 - AEVEL19008.0

Inspect and tighten all parts of the elliptical exerciser

egularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and

a small amount of mild soap. IMPORTANT: Keep liq-

ids away from the console and keep the console

out of direct sunlight. During storage, remove the

batteries from the console.

BATTERY REPLACEMENT

If the console display becomes dim, the batteries

should be replaced; most console problems are the

result of low batteries. To replace the batteries, see

assembly step 3 on page 6.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, you must remove the Left

Pedal Arm (11) and the Left Shield (3). Remove the

Pedal Arm Bolt Set (40), the M10 x 25mm Patch

Screw (22), the M10 Washer (35), and the Wave

Washer (58) from the Left Pedal Arm (11).

Remove the Left Pedal Arm (11). Next, remove the

two M4 x 25mm Screws (56) and the four M4 x 16mm

Screws (42) from the Left Shield (3). Then, remove

the Left Shield.

Locate the Reed Switch (53). Loosen, but do not

emove, the indicated M4 x 16mm Screw (42).

Slide the Reed Switch (53) slightly toward or away

from the Magnet (26) on the Flywheel (17). Then,

retighten the Screw. Turn the left Pedal Disc (15) for a

moment.

Repeat until the console displays correct feedback.

When the reed switch is correctly adjusted, reattach

the left shield and the left pedal arm.

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even when

the resistance is adjusted to the highest setting, the

drive belt may need to be adjusted.

To adjust the Drive Belt (19), you must first remove

the left shield. See HOW TO ADJUST THE REED

SWITCH at the left and remove the left shield.

Next, loosen the

M8 x 22mm Flat

Head Screw (41)

and turn the

M10 x 60mm

Bolt (62) until the

Drive Belt (19) is

tight. When the

Drive Belt is tight,

tighten the Flat

Head Screw.

Then, reattach

the left shield.

MAINTENANCE AND TROUBLESHOOTING