Operation Manual

M10 Washer

(35)–2

M10 Split Washer

(59)–2

M10 Locknut

(33)–6

Pedal Arm Bolt Set (40)–2

M6 Locknut

(27)–4

M10 x 25mm Patch Screw

(22)–2

M10 x 68mm Button Bolt

(48)–2

M6 x 36mm Button Bolt

(50)–4

M6 x 48mm Flat Head Screw (36)–4

Wave Washer

(58)–2

M6 x 12mm

Screw (43)–4

M10 x 70mm Carriage Bolt (34)–4

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the

acking materials. Do not dispose of the packing materials until assembly is completed.

n addition to the included tool(s), assembly requires an adjustable wrench , a Phillips

screwdriver , a rubber mallet , and pliers .

Use the drawings below to identify the small parts used for assembly. The number in parentheses below each

drawing is the key number of the part, from the PART LIST near the end of this manual. The number following

the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if

it has been preassembled.