Operation Manual

8
50
8
27
6. Identify the Left Upper Body Arm (6), which is
marked with a “Left” sticker.
Insert the Left Upper Body Arm (6) into one of
the Upper Body Legs (5); make sure that the
h
exagonal holes are on the indicated side.
Attach the Left Upper Body Arm (6) to the
Upper Body Leg (5) with two M6 x 36mm Button
Bolts (50) and two M6 Locknuts (27). Make sure
that the Locknuts are inside the hexagonal
holes. Do not tighten the Button Bolts yet.
Apply a small amount of the included grease to
the left axle on the Upright (2).
Make sure that there are two Small Upper Body
Arm Bushings (49) in the Left Upper Body Arm
(6).
Slide an Upper Body Arm Spacer (47) and the
Left Upper Body Arm (6) onto the left axle on the
Upright (2). Make sure that the Upper Body
Arm Spacer is turned so that the curved side
faces the Upright. Then, press an Axle Cap (14)
onto the axle.
Repeat this step to assemble the Right
Upper Body Arm (8) and the other Upper
Body Leg (5).
Grease
6
47
14
49
5
2
5
6
7
36
11
13
7. Identify the Left Pedal Arm (11), which is
marked with a “Left” sticker.
Attach a Pedal (13) to the Left Pedal Arm (11)
with two M6 x 48mm Flat Head Screws (36).
Attach the other Pedal (not shown) to the
Right Pedal Arm (not shown) in the same
way.
Hexagonal
Holes