Operation Manual

9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

8. Apply a small amount of grease to the axle on

the left Disc Crossbar (16).

Slide the Left Pedal Arm (11) onto the axle, and

hen slide a Wave Washer (58) onto the end of

the axle.

Next, slide an M10 Washer (35) onto an M10 x

5mm Patch Screw (22), and tighten the Patch

Screw into the axle.

Apply grease to a Pedal Arm Bolt Set (40).

Hold the lower end of the left Upper Body Leg

(5) inside the bracket on the Left Pedal Arm

(11). Attach the Left Pedal Arm to the left Upper

Body Leg with the Pedal Arm Bolt Set (40). Do

not overtighten the Bolt Set; the Upper Body

Leg must pivot freely.

Attach the Right Pedal Arm (not shown) to

the right side of the elliptical exerciser in the

same way.

See step 5. Tighten the M10 x 68mm Button

Bolts (48).

See step 6. Tighten the M6 x 36mm Button

Bolts (50).

Grease