Operation Manual

5
Install the iFit Sleep App and Pair Both Sensors
To use two sensors, two persons must have iOS devices (iPhone® 4s and later) or Android devices (Android
4.3 and later) that support BLUETOOTH 4.0 wireless technology.
Each person should visit the App Store℠ or the Google Play™ store, do a search for the free iFit Sleep app, and
install and open the iFit Sleep app on his or her device. Each person should then touch Join to create an iFit
account (or touch Log In to log in to an existing iFit account); each person must have a dierent iFit account
on his or her device.
One person should then follow the instructions in the iFit Sleep app to set up a sensor and pair and sync the
sensor to the iFit Sleep app on his or her device. After the first person does this, the second person should
set up the second sensor and pair and sync it to the iFit Sleep app on his or her device. Following is a summary
of the procedure:
1. Plug one of the small ends of the power cord fully into the
power port on one sensor; do not plug the power cord
into the second sensor yet.
2. Make sure that the power cord is plugged fully into the
power adapter. Then, plug the power adapter into an
appropriate outlet that is close to your bed. The green
indicator on the sensor will light.
3. Make sure that BLUETOOTH is enabled on the first
person’s device. Hold the device close to the sensor,
and touch Set Sensor in the iFit Sleep app. After several
seconds, the sensor will pair with the iFit Sleep app. The
blue indicator on the sensor will light.
4. Plug the remaining end of the power cord into the second
sensor. The green indicator on the sensor will light. Then,
repeat step 3 with the second person’s device.
Note: Each sensor can track only one person; each person
must use a dierent sensor.
5. See POSITION THE SENSOR on page 6.