User's Manual

Printed Documentation
You can control your Lamp module in five ways:
x with your Keychain Remote (such as pressing the Light button as you
approach your location or while in your location)
x via your personal web portal (where you can use QuikControl to turn on or
off lights and set brightness levels)
x from your mobile portal (where you can turn on or off lights and set
brightness levels)
x with an automation (such as automatically turning on the lights when the
Door/Window sensor indicates ’Open’)
x with a schedule (turning lights on or off at particular times, randomly, or on
a repeating basis.)
To control the Lamp module from your Keychain Remote:
Press the Light button to toggle the state of a light controlled by a Lamp module. Pressing
the Light button on the Keychain Remote alternately sends ‘Light Button On’ and ‘Light
Button Off’ signals to your iControl System. So if you use the Keychain Remote Light
button to turn your lights on, then the next signal the Keychain Remote Light button will
send is ‘Light Button Off’. However, you may not experience the desired result. If, for
example – after turning the lights on with the Keychain Remote Light button – you turn
the lights off manually, using QuikControl, or with an automation or schedule, then
pressing the Keychain Remote Light button will send the ‘Light Button Off’ signal and
no change will occur. Pressing the Light button a second time will send the ‘Light Button
On’ signal, and the lights will turn on.
A ‘Light Button On’ signal will always turn (or leave) the lights on to full brightness and
a ‘Light Button Off’ signal will always turn (or leave) the lights off, irrespective of the
brightness level of the lamp when the signal is received.
Note: The Keychain Remote that comes with your Starter Kit is pre-configured to control