User's Manual

ViVOpay Kiosk III User Manual
Page 12 of 19
63.50 [ 2.500
]
2. Locate the four 4.4mm (0.173 inch) mounting holes by holding the ViVOpay Kiosk III
Controller in position and mark the holes. The following diagram shows the spacing on the
holes to be drilled for mounting the ViVOpay Kiosk III Controller.
3. Drill the four 4.4 mm (0.173) mounting holes using a number 17 drill bit.
4. Use four screws and nuts to mount the ViVOpay Kiosk III Controller to the kiosk surface.
(Mounting screws are not provided and must be supplied by the installer.)
5. Tighten the nuts to hold the ViVOpay Kiosk III Controller in position so that it does not move.
2.3.2 Mounting the ViVOpay Kiosk III Controller Using Mounting Tape
1. Position the ViVOpay Kiosk III Controller on the interior of the kiosk making sure that there
is sufficient room for the antenna mounting surface to be fully opened.
2. Attach double-sided tape to the mounting surface.
3. Position the ViVOpay Kiosk III Controller over the mounting tape and gently apply
pressure to hold the controller in position.
2.4 Attaching the Cables from the Antenna to the Controller
1. Attach the SMB end of the cable (220-2457-00) from the antenna to the ViVOpay Kiosk III
Controller.