User's Manual

ViVOpay Kiosk III User Manual
Page 9 of 19
2.2 Mounting the ViVOpay Kiosk III External Antenna
Use the following instructions to mount the antenna on the exterior of the kiosk:
Note: Verify the orientation of the ViVOpay Kiosk III Antenna before marking and drilling the holes.
The two larger holes should be located towards the top of the mounting location to ensure that the
ViVOpay Kiosk III Antenna is oriented correctly with the LEDs at the top.
1. Using the Drill Template for the antenna (630-1046-00), locate and mark the four 4.4mm
(0.173 inch) mounting holes.
2. Using the Drill Template, locate and mark the two 14.0 mm (0.551 inches) access holes
(used for connecting the antenna power and the LED power and data cable to the
ViVOpay Kiosk III).
3. Drill the four 4.4 mm (0.173) mounting holes using a number 17 drill bit.
4. Drill the two 14.0 mm (0.551 inch) holes using a 35/64 drill bit.
5. Remove the nuts from the four mounting screws.
6. Route the end of the cable (220-2457-00) with the RJ45 connector through the left 14.0 mm
(0.551 inch) hole in to the kiosk. Make sure that the front of the antenna will be properly
oriented (not upside down) on the kiosk before inserting the four screws into the mounting
holes.