Datasheet

www.ideal-tek.com
swiss made
This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.
Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.
Thermoplastic Elastomer TPE - ESD safe
TECHNICAL DATA SHEET
General notes:
» TPE Olenic Thermoplastic Elastomer, Permanent Antistatic, ESD Protection
» Soft Plastic, was developed in order to achieve a surface resistance 10
8
-10
9
Ohm
in order to minimize the possibility of charge generation by wearing
Tensile strength 2 MPa ISO 527 ASTM D 638
Tensile elongation 10 +% ISO 527 ASTM D 638
Hardness, Shore 65-75 A D-785
Mechanical properties
Polypropylen compound PP - ESD safe
General notes:
» PP polypropylene-compound
» Hard Plastic, its function is to ground the metal tool (through the operators
hand and the ESD wrist strap)
Temp. of de. under load (1.80 MPa) 56 °C ISO 75 ASTM D 648
VICAT softening point B (49 N) 70 °C ISO 306
Tensile strength at break (5mm/min) 20 MPa ISO 527 ASTM D 638
Elongation at break (5mm/min) >10% ISO 527 ASTM D 638
Tensile modulus +23°C 1650 MPa ISO 527 ASTM D 638
Tensile strength +23°C 190 MPa ISO 527 ASTM D 638
Izod-Impact strength (notched) +23°C 13 kJ/m ISO 179/2C
Mechanical properties
Thermal properties
Density 0.97 g/cm
3
ISO 1183
Other properties
Soft plastic (TPE)
Upper side
Hard plastic (PP)
Bottom side