User Manual

MCP-CPF Process/ISMATEC SA/30.10.07/CB/GP
4
Contents
Safety precautions 6
Warranty terms 9
Product 10
Rear panel 11
Mains voltage 11
Starting the pump 12
Start-up information 12
Operating panel 13
Basic Settings 15
Selecting the program 19
Total volume 19
Setting the stroke volume 20
Zero point calibration
of RH pump heads 22
Pumping
by flow rate 23
Calibrating the flow rate 24
by drive speed 25
Stand-by mode 26
Dispensing
by volume 27
Calibrating the volume 28
Default calibration
Flow rate 29
Volume 29
Dispensing
by time 30
Dispensing by volume
within a pre-set time 31
Intermittent dispensing
by volume 32
by time 33
Sommaire
Mesures de sécurité 6
Conditions de garantie 9
Produit 10
Tableau arrière 11
Tension d’alimentation 11
Mise en route 12
Informations de mise en route 12
Tableau de commande 13
Réglages de base 15
Sélection du programme 19
Volume total 19
Réglage du volume de course 20
Tête de pompe RH
calibration du point zéro 22
Pompage selon
le débit 23
calibration du débit 24
le nombre de tours 25
Fonctionnement en stand-by 26
Dosage
selon le volume 27
calibration du volume 28
Calibration par défaut
du débit 29
du volume 29
Dosage
selon le temps 30
Dosage d'un volume
en une unité de temps 31
Dosage par intervalles
de temps 32
de volume 33
Inhaltsverzeichnis
Sicherheitsvorkehrungen 6
Garantiebestimmungen 9
Produkt 10
Geräterückwand 11
Netzspannung 11
Inbetriebnahme 12
Startinformation 12
Bedienungspanel 13
Grundeinstellungen 15
Programmwahl 19
Total Volumen 19
Hubvolumen einstellen 20
Nullpunkt einstellen beim
RH-Pumpenkopf 22
Pumpen
nach Fließrate 23
Fließrate kalibrieren 24
nach Drehzahl 25
Standby-Betrieb 26
Dosieren
nach Volumen 27
Dosiervolumen kalibrieren 28
Default-Kalibration
Fließrate 29
Volumen 29
Dosieren
nach Zeit 30
Volumendosierung
in einer Zeiteinheit 31
Intervall-Dosieren
nach Volumen 32
nach Zeit 33