User Manual

ICELOG-07 Mobile Elite Manager
Page 14
 Anti-static Discharge: If a user open the rear panel of the ICELOG-07, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the system
Step 2: Charging the system
Step 3: Install a microSD card
Step 4: Install a SIM card
Step 5: Connect peripheral devices
Step 6: Power up the system Step 0:
3.4 Charging the System
WARNING:
When charging the system, make sure a power supply with the correct
input voltage is being fed into the system. Incorrect voltages applied to
the system may cause damage to the internal electronic components
and may also cause injury to the user.