User manual

power supply. The plug must therefore be
easily accessible after installation.
Install the appliance
well away from sour-
ces of heat such as ra-
diators, boilers, direct
sunlight etc. Make
sure that air can circu-
late freely around the
back of the cabinet.
To ensure best per-
formance, install the
appliance at least 100 mm between the top
of the cabinet and the wall unit. To allow the
door to open, install the appliance at least
60 mm between the cabinet and the wall unit
if the appliance is placed in a corner and the
side with the hinges facing the wall. Accurate
levelling is ensured by some adjustable feet
at the base of the cabinet.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class in-
dicated on the rating plate of the appliance:
Climate class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried
out by a qualified electrician or competent
person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be ob-
served.
45 mm
100mm
10 mm
1 2
3
4
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
1
Green and Yellow: Earth
3
Brown: Live
5
Blue: Neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter “E“ or by the earth symbol
or
coloured green and yellow.
2. Connect the wire coloured blue to the ter-
minal either marked with the letter “N“ or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
4
is secure
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
ENGLISH 14