User manual

Problem Possible cause Solution
The appliance has no power.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
The compressor oper-
ates continually.
The temperature is not set cor-
rectly.
Set a higher temperature.
The door is not closed correct-
ly.
Refer to "Closing the door".
The door has been opened
too frequently.
Do not keep the door open lon-
ger than necessary.
The product temperature is
too high.
Let the product temperature
decrease to room temperature
before storage.
The room temperature is too
high.
Decrease the room tempera-
ture.
Water flows on the rear
plate of the refrigerator.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water
flows into the water collector.
Make sure that products do not
touch the rear plate.
Water flows on the
ground.
There is too much water in the
air deflector.
Clean the air deflector.
The temperature in the
appliance is too low/
high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre. You can find the list at the
end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover.
3. Replace the
lamp with one
of the same
power and
specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
ENGLISH 11