User manual

Troubleshooting
The appliance does not start or it stops dur-
ing operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, different indicators
flash continuously or intermittently at the
same time to show an alarm code.
Alarm code Problem
• The indicator of the set programme flash-
es continuously.
• The end indicator flashes 1 time intermit-
tently.
The appliance does not fill with water.
• The indicator of the set programme flash-
es continuously.
• The end indicator flashes 2 times intermit-
tently.
The appliance does not drain the water.
• The indicator of the set programme flash-
es continuously.
• The end indicator flashes 3 times intermit-
tently.
The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Problem Possible cause Possible solution
The programme does
not start.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
The appliance door is open. Close the appliance door.
The fuse in the fuse box is
damaged.
Replace the fuse.
The appliance does
not fill with water.
The water tap is closed. Open the water tap.
The water pressure is too low. Contact your local water au-
thority.
The water tap is clogged or
there is limescale on it.
Clean the water tap.
The filter in the water inlet hose
is clogged.
Clean the filter.
The water inlet hose has a kink
or a bend.
Make sure that the position of
the hose is correct.
The anti-flood device is on.
There are water leakages in
the appliance.
Close the water tap and con-
tact the service.
ENGLISH 14