User manual

Programme
1)
Degree of soil
Type of load
Programme
phases
Duration
(min)
Energy
(kWh)
Water
(l)
3)
Fresh soil
Crockery and
cutlery
Wash 60 °C
Rinse
30 0.8 8
4)
Normal soil
Crockery and
cutlery
Prewash
Wash 50 °C
Rinses
Dry
120 - 130 0.8 - 0.9 12 - 13
5)
All Prewash 11 0.1 5
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the
temperature stays at 70 °C for 10 to 14 minutes.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with
normal soil. (This is the standard programme for test institutes).
5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad
odours to come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
[e-mail]
Write down the product number (PNC) that is on the rating plate.
Options
Acoustic signals
The acoustic signals operate in these condi-
tions:
• When the programme is completed.
• A malfunction occurs to the appliance.
Factory setting: on.
You can deactivate the acoustic sig-
nals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to ‘SETTING AND
STARTING A PROGRAMME’.
3. Press and hold the programme button
until the programme indicator (A) flash-
es and the programme indicator (B)
comes on.
4. Press immediately the programme but-
ton.
• The programme indicator (A) comes
on with a fixed light.
• The programme indicator (B) starts to
flash.
5. Wait until the programme indicator (A)
goes off and the end indicator comes on
(the programme indicator (B) continues
to flash).
• The acoustic signals are on.
6. Press the programme button. The end
indicator goes off.
• The acoustic signals are off.
7. Deactivate the appliance to confirm the
setting.
Activating the acoustic signals
1. Refer to ‘Deactivating the acoustic sig-
nals’, step (1) through (4).
ENGLISH 7