Installation guide

Raised panels:
A raised panel design can be created by screwing or gluing wood
panels to 1/4"(6.35 mm) backing or by using 3/4"(19 mm) stock
with routed edges. Raised panels should be spaced 21/4''
(5.70 cm) from the back edge of the handle to allow room for
fingers to grasp the handle.
1/8"
(3.18 ram)
l/s" (_
(3.18 mm)
A
_15%"
(39.3 cm)
C
15%"
(39.3 cm_
B
(3,18 ram)
V8"
(3.16 mm)
191/4,,
(49.0 cm)_
B
291/4"
(74.4 cm)
321/2''
(82.7 cm)
Model Size A C
23' 211/8" 647/8''
(654 L) (53.7 cm) (164.9 cm)
25' 203/4'' 673/4''
(694 L) (52.7 cm) (172.2 cm)
Routing Dimensions for Custom Panels more than
1/4"(6.35 mm) thick
Handle side detail
24/2 ''
(63.5.mm) ,_
mlrl.
+1
=v,..{6.3,minI ox.]
11/2" (38..1 ram) panel
handle tara.
Top, bottom and side trim detail
_(__1/4,,
(&35 ram) max_
1/2,,J
(12.7 ram)
rain.
panel--
Expmosion Hazard
Keep flammable materials and vapors, such as
gasomine, away from refrigerator.
Faimure to do so can resumt in death, explosion, or fire,
NOTES:
• The cabinet depth refrigerator can be installed into a recessed
opening, at the end of cabinets or as a freestanding
refrigerator.
• If you are installing the refrigerator to fit flush with the front of
the base cabinets, all shoe molding and baseboards must be
removed from the rear of the refrigerator opening.
• For full-overlay cabinet doors, the height of the opening must
be 691/s'' (175.6 cm).
• Location should permit doors to open fully. See the "Door
Swing Dimensions" section.
• Do not install the refrigerator near an oven, radiator, or other
heat source, nor in a location where the temperature will fall
below 55°F (13°C).
• Floor must support refrigerator weight (more than 600 Ibs
[272 kg], door panels and contents).
Electdcam Shock Hazard
Pmuginto a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord.
Failure to follow these instructions can resumt in death,
fire, or electricam shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection,
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.