User's Manual

70-M USER’S MANUAL
70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso. 15
70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.
T70MH3D TRANSMITTER MODEL
BASE CHANNEL CHANGE MODE (Press “RIGHT” and “START” functions
simultaneously) -> Message in the LCD display: “FREQ CHANGE”
+
3) The current base channel information is displayed:
“Freq Change”
“Channel NN” -> (01,02,03……….MAXCAN) NN = 01,02,03,…………, MAXCAN
MAXCAN = 11 in 870 MHz
MAXCAN = 69 in 433MHz and 915MHz
4
)
Use “UP”and ”DOWN” functions to chan
g
e the current base channel:
With “DOWN” function, choose the units of the new channel.
Remark: 0 -> “no touch” to programme channels from 1 to 9.
With “UP”
,
function choose the number of units of ten of the new channel.
5) To validate the new channel, inmediately, press “START” .
Remark: If “START” function is not pressed inmediately, the new base channel is
updated after a few seconds.
The new channel information will be displayed in the LCD:
“Freq Change”
“Channel __” -> (01,02,03……MAXCAN) NN = 01,02,03,…………, MAXCAN
MAXCAN = 11 in 870 MHz
MAXCAN = 69 in 433MHz and 915MHz
1
)
With the transmitter switched off
,
p
ress “ON/OFF”. Transmitter in stand-b
y
or LOW CONSUMPTION mode.
2
)
Enterin
g
in the base channel chan
g
in
g
mode:
6) Updating and sending the new base channel data to the receiver.(the message blinks in the LCD display).
7) Once the new base channel is recorded in the receiver the transmitter switches to stand-by or LOW
CONSUMPTION mode. (LCD display switches off).
Note1: To leave without updating the change, press “ESC” .