User's Manual

70-M USER’S MANUAL

70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso. 21

70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.

6.8 PROGRAMATION (TRANSMITTER MODEL T70MH3D)

The availability to enter in programming mode is restricted to transmitter’s models with LCD (model T70MH3D ->

Remote Programmer).

The software architecture presents this following message’s levels:

M E S S A G E

1 . X1

M E S S A G E

1 . X1 . X2

M E S S A G E

1 . X1 . X2 . X3

M E S S A G E

TRANSMITTER’S SWITCH ON PROCESS

With the transmitter switched off, press “ON/STOP” during 2 secs. and the following message is displayed in the LCD:

I N I T I A L I Z I N G

P L E A S E W A I T

This message will remain in the LCD display when reading the internal EEPROM. Finally, the transmitter will

switch off remaining in switched off mode, (no message will be displayed); only the battery level icon will be

displayed:

[▓ ▓ ▓] / [__▓ ▓] / [___ ▓] / [_____] (different battery level indications: full, medium, low and empty).

SEQUENCE TO ACCESS TO PROGRAMATION MODE

With the transmitter switched off, press “ENTER” and “SART” simultaneously, during 3 secs. The message “PROGRAMATION”

will be displayed in the LCD.

Programming mode sequence activation from switched off mode.

P R O G R A M A T I O N

Pressing ESC, the transmitter turns to “switched off” mode.

Pressing ENTER, the software menu is available (use “UP” / “DOWN” arrows to navigate in the software):

VALIDATE “ENTER” / ACCESS TO A LOWER LEVEL OF THE MENU

LEAVE “ESC” / ACCESS TO AN UPPER LEVEL OF THE MENU

DOWN