User's Manual

70-M USER’S MANUAL
70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso. 5
70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.
2.3.- FCC RECOMMENDATIONS (only valid for equipment that works in 915MHz ISM band)
3.- INSTALATION / SYSTEM ASSEMBLY
3.1.-TRANSMITTER
Proceed to open the transmitter’s battery compartment and introduce the supplied batteries into the battery
housing (2 AA type 1,5V alkaline batteries) respecting the +/- polarity, indicated inside the battery housing.
1
2
3
Abrir
Open
Cerrar
Close
Abrir
Open
Cerrar
Close
Cerrar
Close
Abrir
Open
2
3
1
“Open” the safety lock: rotate in the direction
indicated by the arrow.
“Open” lock tab: press in the direction
indicated by the arrow.
“Open” battery housing cover: rotate in the
direction indicated by the arrow.
Procedure to o
p
en the mechanism of the batter
y
housin
g
:
“Close the safety lock”: rotate in the
direction indicated by the arrow.
1
“Close lock tab”: press in the direction
indicated by the arrow.
2
“Close” battery housing cover: rotate in the
direction indicated by the arrow.
3
Procedure to close the mechanism of the
battery housing:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
To comply with FCC RF exposure compliance requirements, this device and its antenna must
not be co-located with, or operating in conjunction with, any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rul.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Crane’s identifier sticker