SDS

Material Safety Data Sheet
Report No.: ZRLK1501210002 Page 5 of 9
Methods and materials for Containment Stop the leak if safe to do so. Contain the spilled
liquid with dry sand or earth. Clean up spills
immediately.
Methods and materials for cleaning up Absorb spilled material with an inert absorbent (dry
sand or earth). Scoop contaminated absorbent into an
acceptable waste container. Collect all contaminated
absorbent and dispose of according to directions in
Section 13. Scrub the area with detergent and water;
collect all contaminated wash water for proper
disposal.
Section 7 – Handling and Storage
Handling Do not dismantle, open or shred secondary Li-ion
Battery;
Don’t handling Polymer Li-ion Batterywith
metalwork. Do not open, dissemble, crush or burn
battery. Ensure good ventilation/ exhaustion at the
workplace.
Prevent formation of dust.
Information about protection against explosions and
fires: Keep ignition sources away- Do not smoke.
Storage If the Li-ion Battery is subject to storage for such a
long term as more than 3 months, it is recommended
to recharge the Li-ion Battery periodically.
3 months: -10℃~+40℃, 45 to 85%RH
And recommended at -20℃~+25℃ for long period
storage.
The capacity recovery rate in the delivery state
(50% capacity of fully charged) after storage is
assumed to be 80% or more.
The voltage for a long time storage shall be
3.7V~4.0V range.
Do not storage Li-ion Battery haphazardly in a box
or drawer where they may short-circuit each other or
be short-circuited by other metal objects.
Keep out of reach of children.
Do not expose Li-ion Battery to heat or fire. Avoid
storage in direct sunlight.
Do not store together with oxidizing and acidic
materials.