Instructions / Assembly

12
Install Canopy
Loosen 1 screw from the key hole of the mounting bracket bottom and remove 1 screw
from the round hole of the mounting bracket bottom.
Slide the canopy up to the mounting bracket and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until it locks in place at the narrow section of the
key hole, secure it by tightening the 1 set screw to the key hole.
Secure the screw removed from the round hole into the round hole.
Finally attach the canopy cover to canopy and secure it by pushing the lugs into the holes.
Figure 12
Attach Fan Blades
Attach the blade to blade bracket kit and secure the blade to blade holder by tightening 3 screws.
Figure. 13
Attach the blade bracket assembly to motor and secure it by tightening the 2 screws. Figure 14
Repeat to install the other blades.
Finally install the bottom cover to shaft of motor by rotating it clockwise
Figure 12
Figure 13
Figure 14