Instructions / Assembly

13
The control system has a last memory function. The system stores the current setting in memory
upon power down and restore setting on next power up.
The remote control and fan are pre-programmed. If, however they don’t function together when
first installed, or you wish to control 2 fans using the same remote, or pair a replacement remote
control to your existing fan, use the following procedure.
Remote Pairing Instruction
DO NOT PRESS ANY OTHER BUTTONS DURING THIS PROCESS
1. Disconnect power to the fan and wait 1 min.
2. Turn on power to fan and wait 5 seconds.
3. Within 30 sec., press and hold “Power” (ON/OFF) button for 6 sec.
4. Once receiver has detected the signal it will beep and the programming procedure is complete.
REMOTE CONTROL
Figure 15