Operation Manual

iLuv
TM
Stereo Audio System for Your iPod V11M11_IM_EN_10172007
www.i-Luv.com - 13 -
OPERATIONAL INSTRUCTIONS
IMPORTANT:
1. Occasionally, files on your iPod may become corrupted. This may cause erratic behavior with your iLuv products. Apple recommends visiting their
website www.apple.com to obtain instructions on resetting or restoring your iPod to factory settings.
2. It is imperative to your iPod and the built-in universal dock that you use the correct dock adapter for your iPod and that the dock adapter fits
appropriately into the built-in universal dock. Ignoring these rules can cause severe damage to your iPod. Please refer to the section “Installing the
Dock Adapter” to install the dock adapter properly before operating i166 with your iPod.
Listening to your iPod
1. Press the POWER/FUNCTION button on the top panel or remote control to Power on the unit.To select iPod mode, press the
POWER/FUNCTION button again until the “iPod” icon is shown on the top of display.
2. While the iPod mode is on, insert your iPod to the universal dock and it will switch from play mode to pause mode or from
pause mode to play mode. If the unit is not connected to an iPod, the background light will remain on, insert the iPod into the
dock and press PLAY to continue playback.
3. Press the PLAY/PAUSE button on top panel or remote control to control the play and pause functions.
4. Press the TUNE/SKIP button on top panel or remote control to select previous or next song.
5. Press the VOLUME + / VOLUME – button on top panel or remote control to adjust the VOLUME level of this unit as desired.
Controlling your iPod using the Remote Control
Press the MENU/TIMER/MEMORY button on the remote control, the iPod will go to the previous menu. Press the iPod UP/ DOWN button on the remote
control to select up or down of the iPod menu; then press the ENTER button to enter selected menu.
Listening to the Radio
Note: Unwind and extend antenna to its full length. It may be necessary to adjust the direction of this wire antenna until you find the
position that provides the best reception for your favorite FM stations.
1. Press the POWER/FUNCTION button on the top panel or remote control to Power on the unit. To select FM or AM radio, press
the POWER/FUNCTION button until “FM” or “AM” icon is shown on the top of display.
2. FM/AM frequency will show on the display.