Owner's Manual

STEP 6 (See Diagram 6)

A.) Attach the Butterfly Base (#18) to the Front Vertical Beam (#2). Secure it with one 4 ¾”

Bracket (#27), two M10 x 3 ½” Carriage Bolts (#78), ∅ ¾” Washers (#94), and M10

Aircraft Nuts (#96).

B.) Insert the Right Butterfly (#21) through the right hole on the Butterfly Base. Secure it with

one M12 x 5/8” Allen Bolt (#83) and ∅ 1 ½” Washer (#73). Plug a ∅1 ½” Round End Cap

(#63) to the end opening on the Butterfly. Repeat the same step to install the other side.

C.) Insert one Butterfly Handle (#17) through the pivot hole on the Right Butterfly (#21).

Secure it with one M12 x 5/8” Allen Bolt (#83) and ∅ 1 ½” Washer (#73). Secure a M10 x

1” Allen Bolt (Half Thread) (#90) through the slotted hole on the pivot into the Handle.

Repeat the same step to install the other side.

DIAGRAM 6