Owner's Manual

STEP 7 (See Diagram 7)

A.) Place the Seat Pad (#22) onto the Seat Post (#13). Secure it with two M8 x 1 5/8” Allen Bolts

(#89) and ∅ 5/8” Washers (#93). Insert the Seat Post (#13) into the opening on the Seat

Support (#10). Thread a Lock Knob (#49) on the Seat Support (#10) to obtain the desired

height of the Seat.

B.) Insert one Foam Roll Tube (#30) halfway through the hole on the Seat Post (#13). Insert one

Foam Roll Tube (#30) halfway through the hole on the Leg Developer (#12). Push four Foam

Rolls (#71) onto the Tubes. Plug four Foam Roll End Caps (#65) to the ends.

DIAGRAM 7