Owner's Manual

STEP 8 (See Diagram 8 & Cable Loop Diagram)

A.) Attach the 174” Upper Cable (#36) to the opening at the front of the Upper

Frame (#3). Note: The Ball Stopper on the cable should be underneath the

Frame.

B.) Attach a Pulley (#50) to the slotted opening. Then attach two ∅7/8” x 5/8” Pulley

Bushings (#67) to the holes on both sides. Align the holes and secure it with one

M10 x 2 ½” Allen Bolt (#85) and M10 Aircraft Nut (#96).

C.) Draw the Cable towards the back of the machine to the opening on the Upper

Frame. Repeat the step B above to install a Pulley.

D.) Draw the Cable around the Pulley then pull back towards the upper opening on

the Front Press Base (#14).

E.) Attach a Pulley to the opening in between the Front Press Base. Secure the

Pulley with one M8 x 6 ¼” Axle (#35) and two M8 x ½” Allen Bolts (#47).

F.) Draw the Cable around the Pulley then pull back towards the upper opening on

the Front Vertical Beam (#2). Repeat the step B above to install a Pulley.

G.) Draw the Cable around the Pulley then pull the Cable back towards the lower

opening on the Front Press Base. Repeat the step D above to install a Pulley.

H.) Install another pulley to the lower opening on the Front Vertical Beam (#2) as

described in Step B above. Draw the Cable underneath the Pulley towards the

back of the machine to the first bracket on the Upper Frame (#3).

I.) Attach a Pulley to the Bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#87),

two ∅ ¾” Washers (#94), and one M10 Aircraft Nut (#96). Pull the Cable over

the Pulley and downward.

J.) Attach a Pulley to the Cable. Place the Pulley in between an Angled Double

Floating Pulley Bracket (#25). Secure the Pulley with one M10 x 1 ¾” Allen Bolt

(#87), two ∅ ¾” Washers (#94), and one M10 Aircraft Nut (#96). Let the

Bracket hanging for now.

K.) Pull the Cable upward towards the Top Socket Assembly (#5). Install a Pulley

(#50) to the first hole. Then install another Small Pulley (#51) to the second

hole. Draw the Cable over the two Pulleys then downward to the Selector Rod

(#41). Thread the tip of the Cable into the hole on the Selector Rod.