Owner's Manual

STEP 10 (See Diagram 10 & Cable Loop Diagram)

A.) Attach one end of the 87” Butterfly Cable (#37) to the clip on the Right Butterfly (#21). Draw

the Cable to the right open bracket on the Butterfly Pulley Bracket (#19).

B.) Attach a Pulley to the Bracket and secure it with one M10 x 1 ¾” Allen Bolt (#87), two ∅ ¾”

Washers (#94), one 2 7/8” L-shaped Bracket (#98), and one M10 Aircraft Nut (#96).

C.) Draw the Cable underneath the Pulley then pull upward to the Crossed Double Floating

Pulley Bracket (#24) previously installed in Step 9. Install another Pulley.

D.) Pull the Cable around the Pulley then downward back to the Butterfly Pulley Bracket (#19).

Repeat the procedure (B) above to install another Pulley.

E.) Pull the Cable underneath the Pulley towards the Left Butterfly (#20). Attach the end of the

Cable to the clip on the Left Butterfly (#20).

DIAGRAM 10