Owner's Manual

STEP 3 (See Diagram 3)

A.) Attach the Backrest Board (#23) to the Backrest Support (#16). Secure it with two M8 x 1

5/8” Allen Bolts (#89) and ∅ 5/8” Washers (#93).

B.) Push two ∅ 1” Bushings (#70) to the holes on the Front Vertical Beam (#2) from both sides.

Attach the Backrest Support (#16) to the holes. Secure it with one M12 x 3 ½” Allen Bolt

(#80), two ∅ 1” Washers (#95), and one M12 Aircraft Nut (#97). Secure the Backrest

Support with a Pull Pin (#48) on the Front Vertical Beam (#2).

C.) Attach the Seat Support (#10) to the Front Vertical Beam (#2). Secure it with One M10 x 2

¾” Carriage Bolt (#79), ∅ ¾” Washer (#94), and M10 Aircraft Nut (#96). Push a 2” Flat End

Cap (#66) into the front end of the Seat Support (#10).

DIAGRAM 3