Owner's Manual

STEP 10 (See Cable Loop Diagram & Diagram 10)
A.) Attach the 102” Upper Cable (#36) to the front opening on the Upper Frame (#8).
Attach a Pulley (#64) to the opening. Secure it with one M10 x 2 3/8” Allen Bolt
(#96), two Pulley Bushings (#63), and one M10 Aircraft Nut (#18). Draw the Cable
towards the back of the machine. Note: Make sure the Ball Stopper is underneath
the frame.
B.) Attach a Pulley to the opening on the Upper Frame. Secure it with one M10 x 2 3/8”
Allen Bolt (#96), two Pulley Bushings (#63), and one M10 Aircraft Nut (#18).
C.) Draw the Cable around the Pulley and downward. Install a Pulley to the two Double
Floating Pulley Brackets (#32). Secure it with one M10 x 1 ¾” Allen Bolt (#95), two
∅ ¾” Washers (#21), and one M10 Aircraft Nut (#18). Let the bracket hanging for
now. Draw the Cable around the Pulley then upward to the open bracket on the
Upper Frame.
D.) Install a Pulley to the bracket with a L-shaped Cable Retainer (#60).
E.) Draw the Cable around the Pulley then downward to the Selector Rod (#53). Attach
the ring on the Selector Pin (#62) to the Selector Rod (#53). Securely thread the
end of the Cable into the Selector Rod. Use the Nut at the end of the Cable to
tighten down the Bolt.
18