Owner's Manual

STEP 15 (See Diagram 15)

A.) Attach the 216” Leg Press Cable (#40) to the bracket on the back of Leg Press Frame (#25).

Secure it with one M10 x 1” Allen Bolt (#94), two Ø ¾” Washers (#21), and one M10 Aircraft

Nut (#18). Draw the Cable to the open bracket on the Left Seat Support (#11). Install a Pulley

to the bracket. Draw the Cable around the Pulley then back to the open bracket on the Leg

Press Frame. Install another Pulley.

B.) Draw the Cable around the Pulley then through the opening on the Left Seat Support (#11)

and Left Vertical Frame (#6) to the open bracket on the Left Base Frame (#2). Install a Pulley

to the bracket.

C.) Draw the Cable underneath the Pulley then upward to the open bracket on the Vertical Press

Base (#23). Install a Pulley.

D.) Draw the Cable around the Pulley then downward to the open bracket on the Rear Base

Frame (#3). Install a Pulley to the bracket.

E.) Draw the Cable around the Pulley then upward to the Angled Floating Pulley Bracket installed

in Step-14. Secure it with one M10 x 1” Allen Bolt (#94), two Ø ¾” Washers (#21), and one

M10 Aircraft Nut (#18).