NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instruction MARCY WEIGHT BENCH WM PRO Parts List Warranty Ordering Parts Model WM PRO Retain This Manual for Reference 05-16-02 OWNER'S MANUAL IMPEX FITNESS PRODUCTS 14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746 Tel: (800) 999-8899 Fax: (626) 961-9966 www.impex-fitness.com info@impex-fitness.
TABLE OF CONTENTS BEFORE YOU BEGIN...................................................................................... 1 IMPORTANT SAFETY NOTICE..................................................................... 2 HARDWARE IDENTIFIER.....…....................................................................... 3 ASSEMBLY INSTRUCTIONS........................................................................... 4 EXPLODED DIAGRAM……………………………………………………………... 8 PARTS LIST……………………………………………………………………….. 9 WARRANTY.
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1. Keep children and pets away from the machine at all times. DO NOT leave children unattended in the same room with the machine. 2. Only one person at a time should use the machine. 3.
3
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury. STEP 1 (See Diagram 1) A.) Connect the Left and Right Upright Beams (#1) & (#2) by a Cross Brace (#3) in the midspan. Align the holes and secure them with one Bracket (#16), two M10 x 3 ¾” Carriage Bolts (#41), two ∅ ¾” Washers (#48), and two M10 Aircraft Nuts (#47) on each end of the Cross Brace.
STEP 2 (See Diagram 2) A.) Attach the Seat Support Bar (#14) to the holes in between the two Seat Brackets (#13). Slide the Seat Brackets onto the pivot on the Main Seat Support (#4). B.) Place the Seat (#25) onto the Seat Brackets. Secure it with four M6 x 1 3/8” Hex Bolts (#39) and ∅ ½” Washers (#50). Insert Seat Support Bar (#14) into the opening on the Main Seat Support. Insert a 3 ¾” L-shaped Pin (#21) through the holes on Main Seat Support and Seat Support Bar.
DIAGRAM 2 6
STEP 3 (See Diagram 3) A.) Insert the Leg Developer Holder (#10) into the top opening on the Main Seat Support (#4). Align the hole on the ∅3” x 1 ¾” Sleeve (#36) to the hole on the font post. Secure the Sleeve with a ½” Philips Screw (#43). Use a Lock Knob (#42) to lock the Leg Developer in position. B.) Attach the Leg Developer (#11) to the bracket on the Leg Developer Holder (#10). Secure it with an Axle (#23), two ∅ 5/8” Washers (#49), and two M8 x 5/8” Allen Bolts (#40). C.
8
PARTS LIST KEY NO.
IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing or repairing, at IMPEX's option. All returns must be pre-authorized by IMPEX.